Sanwa M11X Operating Manual page 24

adjustable rate control
ACT/INH Setting
1) To use the Steering Adjustable Rate Control function, it must be
Activated. Press the ENTER key to move the cursor to ARC then press
the INC/+ or DEC/- keys to either ACT (Activate) or INH (Inhibit) the
Adjustable Rate Control function.
The ARC ST ACT/INH setting can be assigned to any Push-Button
switch using the Key Assign function. See page 50 for more
information. By using this function, switching Adjustable Rate Control 'ON'
or 'OFF' can be selected during model operation.
[ TH ] THrOTTLE AdjuSTABLE rATE CONTrOL
Throttle Adjustable Rate Control can be adjusted from Mild, Linear and Quick. In general, reduce the Adjustable Rate Control
value on a slippery track or with a model that has a higher-torque motor or engine. Increase the Adjustable Rate Control value on
a high-grip track or with a model that has a lower-torque motor or engine.
The High throttle side and the Brake side can be set independently.
RATE Setting
1) Press the Function key and move the cursor to [TH] in the ARC
Programming Window. The cursor will default to RATE.
2) To adjust the High throttle setting, pull the throttle trigger back. The
cursor will point to the left. Press the INC/+ or DEC/- keys to set the
desired RATE value.
3) To adjust the Brake side setting, push the throttle trigger forward. The cursor will point to the right. Press the INC/+ or DEC/-
keys to set the desired RATE value.
ARC TH RATE setting range is between -100% (Mild) to 100% (Quick). The default setting is 0% (Linear).
POINT Setting
1) Press the ENTER key to move the cursor to POINT.
2) To adjust the High throttle setting, pull the throttle trigger back. The
cursor will point to the left. Press the INC/+ or DEC/- keys to set the
desired POINT value.
3) To adjust the Brake side setting, push the throttle trigger forward. The
cursor will point to the right. Press the INC/+ or DEC/- keys to set the
desired POINT value.
ARC TH POINT setting range is between 5 to 95. The default setting is 50.
ACT/INH Setting
1) To use the Adjustable Rate Control function, it must be Activated. Press
the ENTER key to move the cursor to ARC, then press the INC/+ or
DEC/- keys to either ACT (Activate) or INH (Inhibit) the Adjustable Rate
Control function.
The ARC TH ACT/INH setting can be assigned to any Push-Button
switch, using the Key Assign function. See page 50 for more
information. By using this function, switching Adjustable Rate Control 'ON'
or 'OFF' can be selected during model operation.
Page 24