Sanwa M11X Operating Manual page 56

fail safe
Clearing Fail Safe Settings
1) Press the ENTER key to move the cursor next to the channel you
would like to clear the Fail Safe setting from.
2) To reset the predetermined position to 0%, press the INC/+ and
DEC/- keys at the same time.
3) To change the Fail Safe setting to either HOLD or FREE, press the
INC/+ or DEC/- keys to set the desired value.
4) Repeat the previous procedures to clear the Fail Safe settings for the desired remaining channels.
[ B - FAIL SAFE ] BATTERY VOLTAGE FAIL SAFE SETTING
When TH :FS Percentage is set, [B-FAIL SAFE] menu activates. The Battery Fail Safe menu allows you to set a custom voltage that
the Fail Safe function will Activate at. This useful if you're using servos with a higher than normal current draw that might run out of
power before the receiver does.
The receiver will operate down to 2.5 volts, however, the minimum operating voltage of most servos is higher than that.
B-F/S Setting
1) Press the Function key to move cursor to [B-FAIL SAFE] in the
Programming Window. The cursor will default to B-F/S.
2) Press the INC/+ or DEC/- keys to set the desired value.
INH - Battery Fail Safe is not Active.
ACT - Battery Fail Safe is Active. Fail Safe will Activate when the receiver battery reaches the custom value in the
RX-V setting.
RX-V Setting
1) Press the ENTER key to move cursor to RX-V, then press the INC/+
or DEC/- keys to adjust the desired receiver voltage value.
RX-V setting range is 3.5V to 5.0V. The default setting is 3.8V.
Page 56