Servo Monitor - Sanwa M11X Operating Manual

servo monitor

The Servo Monitor function displays the output levels of the four different channels in bar graph form, allowing you to monitor servo
operation in a virtual manner. This allows you to see servo movement and make setting changes without having the receiver
turned on. When used in conjunction with the Display Switch, the Servo Monitor function allows you to see servo movement virtually
and make setting changes without the transmitter actually transmitting a signal. Using the Servo Monitor function while making
setting changes can slso make it easier to understand the setting changes you're making.
1) Press the Function key to highlight the SERVO menu.
2) Moving the different transmitter controls will display the actual movement
on the Servo Monitor in the Programming Window.
Servo Reversing (REV) is not reflected in the Servo Monitor. The indications on the graph shows the direction of the
rransmitter input control (Steering Wheel, Throttle Trigger, Auxiliary Function, and 4th Channel Brake).
3) Press the key to display the Servo Monitor function screen in the Information Window. This allows you to view the Servo
Monitor function while making setting adjustments in many of the Programming Menus.
Programming
Window
The Servo Monitor function screen can be displayed in the Information Window while in the following Programming Menus:
Function Page 1
D-RATE
EPA
EXP
ARC
SPEED
ALB
TR-CTL
If the bar graph always shows an amount of servo movement in one direction even though the servos are centered,
the graph could be displaying the amount of servo Sub-Trim for that particular channel.
Function Page 2 Function Page 3
SUB-T VR-ADJ
TIMER* BATT
REV
S-POS
TH-HLD
pressing the
BR-MIX
SERVO
*Cannot be displayed in the [LAP] sub-menu.
Page 45
Function Page 2 (SERVO)
Information
Window
While in a Programming Menu that does not support the
Servo Monitor being displayed in the Information Window,
key will move the cursor back instead.
Servo
Monitor