Sanwa M11X Operating Manual page 36

track timers
Setting Interval Timer One (T1)
1) Press the ENTER key to move the cursor to T1 00', then press INC/+ or
DEC/- keys to set the desired Interval Time in Minutes.
2) Press the ENTER key to move the cursor to T1 00", then press INC/+
or DEC/- keys to set the desired Interval Time in Seconds.
TIIMER INT T1 setting range is 0 minutes to 99 minutes in 1 minute
increments, and 0 seconds to 59 seconds in 1 second increments. The
default setting is 00' minutes and 00" seconds.
Setting Interval Timer Two (T2)
1) Press the ENTER key to move the cursor to T2 00", then press INC/+
or DEC/- keys to set the desired Interval Time in Seconds.
2) Press the ENTER key to move the cursor to T2 00, then press INC/+ or
DEC/- keys to set the desired Interval Time in Milliseconds.
TIIMER INT T2 setting range is 0 seconds to 59 seconds in 1 second
increments, and 0 milliseconds to 90 milliseconds in 10 millisecond
increments. The default setting is 00" seconds and 00 milliseconds.
Starting the Interval Timer(s)
1) In the default configuration, the Interval Timer Switch is assigned to Sw 3. To start the Interval Timer, press the Interval Timer
Switch. Both Interval Timers will start counting up. When Interval Timer T2 reaches the preset time an alarm will sound and
it will reset and begin counting up from zero. When Interval Timer T1 reaches the preset time, a different alarm will sound
and it will reset and begin counting up from zero. Pressing the Interval Timer Switch a second time will reset the Interval
Timers and they will begin counting up from zero again.
The Interval Timer Switch can be assigned to another switch, using the Key Assign function. See page 50 for more
information.
Stopping the Interval Timer(s)
1) The Interval Timer(s) can be stopped using two different methods:
A) By pressing and holding the Interval Timer Switch for 3 seconds.
B) By pressing the INC/+ and DEC/- keys at the same time.
When the Interval Timer(s) are stopped, the Interval Timers function
is automatically turned OFF. To turn the Interval Timers function back
ON, see Turning On the Interval Timers on the previous page.
[ dOWN ] COuNTdOWN TIMEr
The Countdown Timer function can notify you of your model's running time. For example, set the Countdown Timer to 7 minutes.
When the Countdown Timer sounds, refuel. The Countdown Timer accepts settings of up to 99 minutes and 59 seconds. Once
the count down timer has run out, the count up timer starts. This allows you to check the time elapsed since the timer ran out.
(This timer has an alarm that sounds every minute).
Turning On the Countdown Timer
1) Press the Function key to move the cursor to [DOWN] in the Programming
Window. The cursor will default to OFF.
2) Press INC/+ or DEC/- keys to turn the Countdown Timer ON.
Page 36