Ricoh SCRIPT2 Setup Manual page 314

Appendix
Changing the NetBIOS name
Use the hostname command to change the NetBIOS name of the printer.
msh> hostname NetBIOS name of the printer
Note
❒ The NetBIOS name consists of up to 13 alphanumeric characters.
❒ You cannot use a name starting with "RNP" or "rnp".
WINS
Use the wins command to configure the WINS server.
Note
❒ For how to configure the WINS server, see P.105 "Configuring a WINS".
❖ ❖ ❖ ❖ WINS configuration
msh> set wins {on|off}
"on" means active and "off" means inactive.
❖ ❖ ❖ ❖ View settings
6
The following command displays the IP addresses of the WINS server.
msh> wins
Example output:
wins: primary server 192.168.10.1 secondary server
192.168.10.2
wins server current config: primary server 192.168.10.1
secondary server 192.168.10.2 hostname 123456789abcd
ScopeID
Note
❒ The current configuration appears on the second line when DHCP is ac-
tive. When DHCP is not active, there is no second line.
❒ If the network boot setting is changed to another from DHCP, the WINS
server IP addresses that were saved on the printer may differ from the cur-
rent IP addresses.
❖ ❖ ❖ ❖ Address configuration
Specify the WINS server IP addresses.
msh> wins {primary|secondary} address
Use "primary" to specify the primary WINS server address, and use "second-
ary" to specify the secondary WINS server address.
88