Ricoh SCRIPT2 Setup Manual page 309

Protocol
Use the set command to allow/prevent remote access for each protocol.
msh> set protocol {up | down}
Protocol
appletalk
tcpip
netware
netbeui
lpr
ftp
rsh
diprint
web
npmp
snmp
ipp
Note
❒ If you prohibit remote access using TCP/IP and then log out, you cannot use
remote access. If this was a mistake, you can use the printer operation panel
to allow access by TCP/IP.
❒ When you prevent access via TCP/IP, you are also prevented from using lpr,
ftp, rsh, diprint, and web.
Printer status
The following commands can be used to get information about the current status
of the printer.
msh> command
Command Information that is displayed
status Status of printer.
Information about the print jobs.
info Information about the paper tray, output tray
and printer language of the printer.
prnlog [ID] Lists the last 10 print jobs.
netstat Information about the Network Interface
Board.
Note
❒ More information about any print job is displayed when the ID number is
added after the prnlog command.
"up" means active and "down" means
inactive.
Remote Maintenance by telnet
6
83