Yamaha TZ125M1 Owner's Service Manual page 210

STEERING
8. Install:
• Plain washer 1
• Steering shaft nut 2
NOTE:
Apply the lithium soap base grease on the
steering shaft nut thread.
9. After tightening the nut, check the steering
for smooth movement. If not, adjust the
steering by loosening the ring nut little by lit-
tle.
10.Install:
• Steering damper bracket 1
• Pinch bolt (steering damper bracket) 2
To steering damper 3.
NOTE:
When installing the steering damper bracket,
provide a distance a of 9 mm (0.35 in) from its
edge.
C C CAUTION:
Tighten the pinch bolt to specified torque. If
torqued too much, it may cause the steer-
ing damper to malfunction.
11. Install:
• Pin 1
• Plain washer 2
• Steering damper 3
• Clip 4
• Bolt (steering damper) 5
5-49
CHAS
80 Nm (8.0 mdkg, 58 ftdlb)
T
5 Nm (0.5 mdkg, 3.6 ftdlb)
T
18 Nm (1.8 mdkg, 13 ftdlb)
T