Yamaha TZ125M1 Owner's Service Manual page 209

STEERING
4. Install:
• Under bracket 1
NOTE:
Apply the lithium soap base grease on the
bearing.
5. Install:
• Ring nut 1
Tighten the ring nut using the ring nut
wrench 2.
Refer to "STEERING HEAD INSPECTION
AND ADJUSTMENT" section in the CHAP-
TER 3.
6. Check the steering shaft by turning it lock to
lock. If there is any binding, remove the
steering shaft assembly and inspect the
steering bearings.
7. Install:
• Front fork 1
• Steering damper stay 2 (left side only)
• Handlebar 3
• Handle crown 4
NOTE:
• Temporarily tighten the pinch bolt (under
bracket).
• Do not tighten the pinch bolts (handle crown,
steering damper stay and handle bracket)
yet.
5-48
CHAS
1 Nm (0.1 mdkg, 0.7 ftdlb)
T