Yamaha TZ125M1 Owner's Service Manual page 160

CRANKCASE, CRANKSHAFT AND WATER PUMP
NOTE:
• Hold the connecting rod at top dead center
with one hand while turning the nut of the
installing tool with the other. Operate the
installing tool until the crankshaft bottoms
against the bearing.
• Before installing the crankshaft, clean the
contacting surface of crankcase.
• Apply the lithium soap base grease on the oil
seal lip.
C C CAUTION:
Do not use a hammer to drive in the crank-
shaft.
2. Apply:
• Sealant
On the crankcase (right) 1.
Quick gasket
ACC-11001-05-01
F
ACC-11001-30-00
YAMAHA Bond No.1215
90890-85505
YAMAHA Bond No.4
90890-05143
NOTE:
Clean the contacting surface of crankcase (left
and right) before applying the sealant.
C C CAUTION:
If the engine is started soon after reinstalla-
tion, use this quick drying Quick gasket
(ACC-11001-30-00) or YAMAHA Bond No.4.
3. Install:
• Dowel pin 1
• O-ring 2
To crankcase (right).
4-72
ENG
® :
®