Yamaha TZ125M1 Owner's Service Manual page 184

FRONT BRAKE AND REAR BRAKE
5-23
3. Install:
• Brake hose holder 1
• Bolt (brake hose holder) 2
8Nm (0.8 mdkg,5.8 ftdlb)
T
4. Install:
• Brake hose 1
NOTE:
Clamp the brake hose with the end of the
clamp a forward. Refer to "CABLE ROUTING
DIAGRAM" section in the CHAPTER 2.
EC5A5610
Brake fluid
1. Fill:
0
• Brake fluid
Until the fluid level reaches "LOWER" level
line a.
Recommended brake fluid:
DOT #4
W
• Use only the designated quality brake
fluid:
otherwise, the rubber seals may deterio-
rate, causing leakage and poor brake per-
formance.
• Refill with the same type of brake fluid;
mixing fluids may result in a harmful
chemical reaction and lead to poor perfor-
mance.
• Be careful that water does not enter the
master cylinder when refilling. Water will
significantly lower the boiling point of the
fluid and may result in vapor lock.
C C CAUTION:
Brake fluid may erode painted surfaces or
plastic parts. Always clean up spilled fluid
immediately.
A Front
B Rear
CHAS