Yamaha TZ125M1 Owner's Service Manual page 197

FRONT FORK
NOTE:
Record the set position of the adjuster (the
amount of turning in the adjuster to the fully
turned in position) before adjusting it.
C C CAUTION:
If the rebound damping adjuster position is
out of specification, proper damping force
cannot be obtained.
23.Install:
• Push rod 1
• Cap bolt 2
NOTE:
Turn in the cap bolt fully by holding the spring
preload adjuster 4 with your hand until the
rebound damping adjuster 3 hits the push rod
tip.
24.Check:
• Cap bolt clearance a
a
Out of specification ≥ Repeat the steps 21
to 23.
Cap bolt clearance a a :
Zero~2 mm (Zero~0.08 in)
C C CAUTION:
If the cap bolt is installed out of specifica-
tion, proper damping force cannot be
obtained.
25.Install:
• Cap bolt (locknut) 1
NOTE:
Hold the locknut 2 and tighten the cap bolt by
turning the spring preload adjuster 3 with
specified torque.
C C CAUTION:
Do not tighten the cap bolt. It may cause
damage to the spring preload adjuster.
5-36
CHAS
15 Nm (1.5 mdkg, 11 ftdlb)
T