Yamaha TZ125M1 Owner's Service Manual page 169

FRONT WHEEL AND REAR WHEEL
5-8
7. Install:
• Drive chain 1
NOTE:
Push the wheel 2 forward and install the drive
chain.
8. Install:
• Wheel axle 1
NOTE:
• Apply the lithium soap base grease on the
wheel axle.
• Insert the wheel axle from left side.
9. Install:
• Plain washer 1
• Nut (wheel axle) 2
NOTE:
• Apply the lithium soap base grease on the
wheel axle thread.
• Temporarily tighten the nut (wheel axle) at
this point.
a
10.Adjust:
• Drive chain slack a
Drive chain slack:
30~40 mm (1.2~1.6 in)
Refer to "DRIVE CHAIN SLACK ADJUST-
MENT" section in the CHAPTER 3.
11. Tighten:
• Nut (wheel axle) 1
63 Nm (6.3 mdkg, 45 ftdlb)
T
• Adjuster 2
2 Nm (0.2 mdkg, 1.4 ftdlb)
T
• Locknut 3
16 Nm (1.6 mdkg, 11 ftdlb)
T
NOTE:
• Tighten the axle nut while pushing down the
drive chain.
• After tightening the axle nut, tighten the lock-
nut with the turned out the adjuster.
12.Adjust:
• Wheel alignment
Refer to "WHEEL ALIGNMENT ADJUST-
MENT" section in the CHAPTER 3.
CHAS