Yamaha TZ125M1 Owner's Service Manual page 203

HANDLEBAR
7. Install:
• Master cylinder 1
• Master cylinder bracket 2
• Bolt (master cylinder bracket) 3
NOTE:
• Install the bracket so that the arrow mark a
faces upward.
• When installing master cylinder, align the
contacting surface b of the master cylinder
bracket with the punch mark c on the han-
dlebar.
8. Install:
• Grip (left) 1
Apply the adhesive to the handlebar 2.
NOTE:
Before applying the adhesive, wipe off grease
or oil on the handlebar surface a with a lac-
quer thinner.
9. Install:
• "ENGINE STOP" button 1
• Clutch lever holder 2
• Bolt (clutch lever holder) 3
NOTE:
The "ENGINE STOP" button and clutch lever
holder should be installed according to the
dimensions shown.
10.Install:
• Clutch cable 1
NOTE:
Apply the lithium soap base grease on the
clutch cable end.
5-42
CHAS
8 Nm (0.8 mdkg, 5.8 ftdlb)
T
5 Nm (0.5 mdkg, 3.6 ftdlb)
T