Access Code Mode (8S) - Toshiba e-studio166 Service Handbook

2.2.5

Access code mode (8S)

Storing/deleting of the access code, and confirming and changing of the counter value can be done
in the access code mode (8S).
Note: Note:
Department management must be enabled in FUNC-18 (bit-2) before you can use a registered
access code.
<Setting procedure>
Registering the access code
[8][START] Access code
[POWER] [Digital keys]
(3 digits)
Notes:
• Register up to 99 access codes in 3-digit numbers from 001 to 999.
• If the [START] button is pressed with an access code which has been already registered, a
beep sounds and the display returns to the initial screen.
Deleting the access code
Auto search
[INTERRUPT]
[8][START]
[POWER]
Notes:
• Auto search for the access code: Every time the [INTERRUPT] button is pressed, registered
access codes are displayed in order.
• If the [START] button is pressed with an access code which has not been registered previ-
ously, the display returns to the initial screen.
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
Confirm
Access code
[START]
Access code
Access code
[Digital keys]
2 - 13
Stores
value in RAM
[START]
(blinks)
Does not store
value in RAM
[CLEAR]
Confirm
"---"
[FUNCTION
(blinks)
CLEAR]
Deleting
[FUNCTION
CLEAR]
Cancel
[CLEAR]
ERROR CODE AND SELF-DIAGNOSTIC MODE
[POWER]
OFF/ON
[POWER]
OFF/ON
e-STUDIO163/166/203/206
2