Toshiba e-studio166 Service Handbook page 191

11)Skew (inclined image)
Defective area
Drawers
Feed roller
Rollers
Registration roller
Pre-registration guide
CIS unit
Feed system
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 5-11
Step Check items
1 Is the drawer properly installed?
2 Is there too much paper in the
drawer?
3 Is the corner of the paper folded?
4 Are the side guides of the drawer
properly installed?
5 Is the surface of the feed roller dirty?
6 Are the roller and shaft secured?
7 Is the spring detached from the regis-
tration roller?
8 Is the pre-registration guide properly
installed?
9 Is the CIS unit slanted?
10 Is the aligning amount proper?
5 - 31
Prescription
Install the drawer properly.
Reduce paper to 250 sheets or less.
Change the direction of the paper
and set it again.
Adjust the position of the side guides.
Clean the feed roller surface with
alcohol, or replace the roller.
Check and tighten the E-rings, pins,
clips and setscrews.
Attach the spring correctly. Clean the
roller if it is dirty.
Correct it.
Replace the CIS case.
Adjust the aligning amount.
e-STUDIO163/166/203/206
TROUBLESHOOTING
5