Toshiba e-studio166 Service Handbook page 41

Notes:
• The digit after the hyphen in "Code" of the following table is a sub code.
• In "RAM", the SRAM of the board in which the data of each code is stored is indicated. "M"
and "SYS" stands for the MAIN board.
Classi-
Code
fication
200 Devel- Automatic adjustment of
oper auto-toner sensor
(Fuser heater ON)
201 Devel- Correction of auto-toner
oper sensor
(Fuser heater ON)
205 Devel- Developer bias DC output
oper adjustment
210 Charger Main charger grid bias out-
put adjustment
220 Transfer Transfer transformer DC
output adjustment (H)
221 Transfer Transfer transformer DC
output adjustment (C)
222 Transfer Transfer transformer DC
output adjustment (L)
233 Separa- Separation transformer DC
tion output adjustment (H)
234 Separa- Separation transformer DC
tion output adjustment (C)
235 Separa- Separation transformer DC
tion output adjustment (L)
247 Devel- Relative humidity latest
oper value
248 Devel- Drum temperature latest
oper value
270 Devel- Temperature latest value
oper
280 Process Forced performing of idling
for toner recycle
286 Laser Laser power adjustment
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
Adjustment mode (05)
Default
Func- <Accept-
Items
tion
value>
ALL
ALL
<0-255>
ALL
<0-255>
ALL
<0-255>
ALL
<0-255>
ALL
<0-255>
ALL
<0-255>
ALL
<0-255>
ALL
<0-255>
ALL
<0-255>
ALL
<0-100>
ALL
<0-100>
ALL
<0-50>
ALL
ALL
<0-255>
2 - 21
07/02
RAM Contents
able
- - As the value increases,
the sensor output
increases correspond-
ingly.
The value starts chang-
ing approx. 2 minutes
after this adjustment was
started and is automati-
cally set in the range of
2.35 to 2.45 V.
* Selection is disable
when developer unit
is not installed.
(Chap. 3.1)
141 M Corrects the control
value of the auto-toner
sensor setup in 05-200.
* Selection is disable
when developer unit
is not installed.
135 M As the value increases,
the transformer output
increases correspond-
75 M
ingly. Remove the devel-
oper unit and install the
117 M
adjustment jig to make
adjustment.
128 M
(Chap. 3.6)
101 M
65 M
65 M
47 M
50 M Displaying of the relative
humidity latest value.
25 M Displaying of the drum
temperature latest value.
25 M Displaying of the temper-
ature latest value.
- M Perfom this adjustment
before the replacement
of the developer mate-
rial.(The toner is forcibly
removed from the
cleaner.)
60 M When the value
increases, the laser out-
put increases corre-
spondingly.
ERROR CODE AND SELF-DIAGNOSTIC MODE
Proce-
dure
17
3
3
3
3
3
3
3
3
3
2
2
2
6
3
e-STUDIO163/166/203/206
2