Toshiba e-studio166 Service Handbook page 204

(11) While pressing [0] and [2] simultaneously, turn the power ON. Enter the code for the destination
and press the [INTERRUPT] button.
(Destination code: NAD: 1, CND: 86, JPD: 81, Other destinations: 44)
*After pressing the [INTERRUPT] button, wait until the equipment goes into the ready status as it
starts in the normal mode automatically.
(12) Turn the power OFF and then start with the adjustment mode (05).
(13) Set the adjustment value.
Set the adjustment values of the following codes according to the list printed out in advance.
(If the adjustment values could not be printed out because of the SRAM board damage or any
other reason, enter the values on the list output at the last maintenance. If there is no list, enter
the default values.)
05-201 (Correction of auto-toner sensor)
05-205 (Developer bias DC output adjustment)
05-210 (Main charger grid bias output adjustment)
05-220 (Transfer transformer DC output adjustment (H))
05-221 (Transfer transformer DC output adjustment (C))
05-222 (Transfer transformer DC output adjustment (L))
05-233 (Separation transformer DC output adjustment (H))
05-234 (Separation transformer DC output adjustment (C))
05-235 (Separation transformer DC output adjustment (L))
05-305 (Image location adjustment of secondary scanning direction (scanner section))
05-306 (Image location adjustment of primary scanning direction (scanner section))
05-340 (Reproduction ratio adjustment of secondary scanning direction (scanner section))
05-401 (Adjustment of primary scanning direction reproduction ratio (printer))
05-405 (Adjustment of primary scanning direction reproduction ratio (copy))
05-410 (Adjustment of primary scanning laser writing start position (copy))
05-411 (Adjustment of primary scanning laser writing start position (printer))
05-421 (Adjustment of secondary scanning direction reproduction ratio)
05-440 (Adjustment of secondary scanning laser writing start position (drawer))
05-442 (Adjustment of secondary scanning laser writing start position (bypass tray))
05-430 (Top margin adjustment (blank area at the leading edge of the paper))
05-431 (Left margin adjustment (blank area at the left of the paper along the paper feeding
direction))
05-432 (Right margin adjustment (blank area at the right of the paper along the paper feeding
direction))
05-433 (Bottom margin adjustment (blank area at the trailing edge of the paper))
05-501 (Density adjustment Fine adjustment of "manual density"/Center value (Photo))
05-503 (Density adjustment Fine adjustment of "manual density"/Center value (Text/Photo))
05-504 (Density adjustment Fine adjustment of "manual density"/Center value (Text))
05-512 (Density adjustment Fine adjustment of "automatic density" (Photo))
05-514 (Density adjustment Fine adjustment of "automatic density" (Text/Photo))
05-515 (Density adjustment Fine adjustment of "automatic density" (Text))
Also, set the adjustment values which have been changed for servicing.
(14) Be sure to perform "05-310" with the platen cover or the ADF closed after replacing the SRAM
board.
(15) Turn the power OFF and then start with the setting mode (08).
e-STUDIO163/166/203/206
TROUBLESHOOTING
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
5 - 44
06/05