Self-Diagnosis Modes - Toshiba e-studio166 Service Handbook

2.2

Self-diagnosis Modes

Mode For start
Input check [0]+[3]+
mode [POWER]
Output check [0]+[4]+
mode [POWER]
Test print [0]+[7]+
mode [POWER]
Adjustment [0]+[5]+
mode [POWER]
Setting mode [0]+[8]+
[POWER]
List print mode [9]+[START]
+[POWER]
Access code [8]+[START]
mode +[POWER]
Function set- [1]+[*]+
ting mode [POWER]
Test mode [1]+[3]+
[POWER]
Note: Note:
To enter the desired mode, turn ON the power while two digital keys designated to each mode
(e.g. [0] and [5]) are pressed simultaneously.
Normal
[0][3]
Input check
Warming up
mode
Ready
[POWER]
OFF
*1
To user
*1 Turn OFF the power after using the self-diagnosis modes, and leave the equipment to the user.
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
Contents
Checks the status of input signals.
Checks the status of output signals.
Outputs the test patterns.
Adjusts various items.
Sets various items.
Prints out the data lists of the codes 05/08 and
pixel counter.
Registers / deletes the access code.
Sets the function table.
Checks the operation of the equipment.
[POWER]
ON
[0][4] [0][7]
Output check Test print Adjustment
mode mode mode
State transition diagram of self-diagnosis modes
Fig. 2-1
2 - 3
07/11
For exit
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
[0][5] [0][8] [9][START]
Setting List print Access code
mode mode
ERROR CODE AND SELF-DIAGNOSTIC MODE
Display
[8][START] [1][*]
Function
mode setting mode
e-STUDIO163/166/203/206
2