Toshiba e-studio166 Service Handbook page 225

(9) When updating has started, USB communication data are displayed in the STATUS field, and a
bar indicating the updating status appears at the bottom of the window.
(10) When the program data transmission is completed, the message window shown below appears
on your PC monitor. Click [OK] to finish displaying the status.
(11) Click [Exit] in the Firmware Download window to finish updating.
Note: Note:
The display on the control panel of the equipment during update is as follows; the status of the
equipment and the corresponding software are indicated by the LED.
A : USB communication
B : Data being written on RAM
C : Normally completed
• During the update:
LEDs "B" and "E" or LEDs "B" and "F" are lit.
• When correctly completed:
All the LEDs "A", "B" and "C" blink.
• On an update error:
All the LEDs of D are lit.
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 6-28
Fig. 6-29
D : Download error indication
E : "Program" data
F : "Function" data
6 - 17
07/05
e-STUDIO163/166/203/206
FIRMWARE UPDATING
6