Self-Diagnosis Modes - Toshiba e-STUDIO351c Service Handbook

2.2

Self-diagnosis Modes

Mode For start
Control panel [0]+[1]+
check mode [POWER]
Test mode [0]+[3]+
[POWER]
Test print mode [0]+[4]+
[POWER]
Adjustment [0]+[5]+
mode [POWER]
Setting mode [0]+[8]+
[POWER]
List print mode [9]+[START]+
[POWER]
PM support [6]+[START]+
mode [POWER]
Firmware [8]+[9]+
update mode [POWER]
Notes:
1. To enter the desired mode, turn ON the power while two digital keys designated to each mode
(e.g. [0] and [5]) are pressed simultaneously.
2. When the optional FAX unit is installed, Faxes received automatically during the self-diagno-
sis mode may not be printed out. Be sure to disconnect the modular code from the line con-
nectors (LINE1, LINE2) of the equipment before starting the self-diagnosis mode. Also, be
sure to finish the self-diagnosis mode by turning the power OFF and back ON before connect-
ing the modular code.
To exit from Adjustment mode and Setting mode:
Shut down the equipment. When the power should be turned OFF, be sure to shut down the equip-
ment by pressing the [ENERGY SAVER] button for a few seconds.
<Operation procedure>
• Control panel check mode (01):
[0][1] LED lit/
[POWER] LCD blinking
Notes:
1. A mode can be canceled by [POWER] OFF/ON when the LED is lit and the LCD is blinking.
2. Button Check
Buttons with LED
Buttons without LED
Button on touch panel
• Test mode (03): Refer to "2.2.1. Input check (test mode 03)" and "2.2.2. Output check (test mode
03)".
• Test print mode (04): Refer to "2.2.3. Test print mode (04)".
• Adjustment mode (05): Refer to "2.2.4. Adjustment mode (05)".
• Setting mode (08): Refer to "2.2.5. Setting mode (08)".
e-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE
Contents
All LEDs on the control panel are lit, and all
the LCD pixels blink.
Checks the status of input/output signals.
Outputs the test patterns.
Adjusts various items.
Sets various items.
Prints out the data lists of the codes 05 and
08, PM support mode and pixel counter.
Clears each counter.
Performs updating of the system firmware.
[START] (Button check)
[START]
(Press to turn OFF the LED.)
(Press to display the message on the control panel.)
(Press to display the screen on the control panel at power-ON.)
2 - 24
06/08
For exit Display
[POWER] -
OFF/ON
[POWER] 100% C A4
OFF/ON TEST MODE
[POWER] 100% P A4
OFF/ON TEST PRINT
[POWER] 100% A A4
OFF/ON TEST MODE
[POWER] 100% D
OFF/ON TEST MODE
[POWER] 100% UA A4
OFF/ON LIST PRINT
[POWER] 100% K
OFF/ON TEST MODE
[POWER] -
OFF/ON
[POWER] OFF/ON
(Exit)
June 2005 © TOSHIBA TEC