Removal Of The Scanner; Cleaning Of The Exposure Lamp - Minolta EPI 054 User Manual

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
1139D141AA
1139D142AA

(5) Removal of the Scanner

1151D019AA

(6) Cleaning of the Exposure Lamp

1151D021AA
1076D131
8. Wind the shorter length of the Cable around Pul-
leys A and B.
NOTE
Wind the shorter length of the Cable around the upper
groove in Pulley B (two grooves).
9. Fit the Cable into the groove in the Wire Guide and
hook the spring.
10. Remove the wrench and Cable Holding Jig.
1. Turn the Scanner Drive Gear to move the Scanner
to the right-hand side of the copier. Then, remove
three screws and the Scanner.
1. Remove two screws and the Exposure Lamp Ter-
minal.
2. Slide out the Exposure Lamp.
3. Using a soft cloth dampened with alcohol, clean
the Lamp by wiping its surface gently in one direc-
tion.
4. Clean the Lamp Reflector.
NOTE
When reinstalling the Lamp, use care not to allow the
protruding navel of the Lamp to hit against the Lamp
Reflector and that the protruding navel points toward
the opening in the Lamp Reflector.
D-29