Minolta EPI 054 User Manual page 25

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
No. Part Name
1 Front Door
2 Control Panel
3 Original Scales
4 Original Glass
5 Rear Upper Cover
(Small)
6 Left Hinge Cover
Rear Upper Cover Remove the Original Cover. → Remove No.6, 8 and 9. →
7
8 Right Hinge Cover
9 Upper Right Cover
10 Right Cover
11 Middle Right Cover Remove screws that secure No.11. (23 cpm copier: three/
12 Right Door
13 Multi Bypass Table
Mounting Bracket
1
14 Counter Cover
15 1st Drawer
16
2nd Drawer 2
17 Lower Rear Cover
2
18 Rear Cover
Upper Rear Cover Swing down No.1. → Release and swing up the Upper Half of
19
20 Original Cover
Remove the Original Cover by pulling it up.
Removal Procedure
Swing down No.1. → Remove one screw that secures the Belt.
→ Remove two screws that secure the Front Door (only on
one side). → Slide the Door to the side from which the screws
have been removed.
Swing down No.1. → Remove No.9. → Release and swing up
the Upper Half of the copier. → Remove No.21. → Remove
two screws that secure the control panel and loosen another
five screws that secure the control panel.
Remove two screws that secure the Scales.
Remove the Original Cover. → Release and swing up the
Upper Half of the copier. → Remove the Screw Cover and one
mounting screw of No.5.
Remove the Original Cover. → Remove one screw that
secures the Left Hinge Cover.
Remove one screw that secures No.7.
Remove No.11. → Remove No.9. → Remove two screws that
secure No.10.
15/18 cpm copier: four).
Open No.12 and remove it by lifting it up.
Remove two screws that secure the Multi Bypass Table
Mounting Bracket.
Remove No.14 by snapping if off.
Slide out the Drawer and remove one screw that secures the
Stopper at the rear left corner.
Remove two screws that secure the Lower Rear Cover.
Swing down No.1. → Release and swing up the Upper Half of
the copier. → Remove two screws that secure the Rear Cover.
the copier. → Remove three screws that secure the Upper
Rear Cover.
D-6