Removal Of The Scanner Drive Cable - Minolta EP1080 Service Manual

(3) Removal of the Scanner Drive Cable

•
Remove the Original Cover, Original Scales, and Original Glass.
•
Remove the Middle Right, Upper Right, Right, Upper Left, and Upper Rear Covers.
•
Remove the Left and Right Hinge Covers, Rear Upper Cover (Small), and Rear Upper Cover.
5. Pass the longer length of the Cable through the
U-shaped hole in the Light Blocking Plate and wind it
around the Pulley farther away from the Cable Drive
Gear.
6. Temporarily secure the longer length of the Cable to
the Cable Fixing Bracket, ensuring a distance of 5 ±2
mm for the dimension shown on the left.
7. Wind the shorter length of the Cable around the Pulley
which is nearer to the Cable Drive Gear.
8. Hook the spring onto the shorter length of the Cable
and pull it to hook onto the longer length of the Cable.
9. Check that the dimension noted in step 6 above
measures 5 ±2 mm. Then, secure the Cable Fixing
Bracket.
10. Remove the wrench and peel off the two pieces of
tape.
1. Remove the harness from the two clamps.
2. Remove four screws to remove the Document Feeder
Mounting Bracket.
3. Remove one screw from the Plate.
D-21