Minolta EPI 054 User Manual page 284

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 TROUBLESHOOTING
98.05.15
Copier Take-Up Misfeed Clearing Procedure
Symptom Step
• Paper is not
Does the paper being used
taken up at all. 1 meet product specifica-
tions?
• Paper is station-
Is the paper curled, waved,
ary before the
2 or damp?
Paper Take-Up
Sensor.
Are the Separator Fingers
3 on both sides of the Drawer
in position?
Are the Separator Fingers
4
deformed?
Is the Trailing Edge Stop or
5 Edge Guide in good posi-
tion?
Are the Paper Lifting
6 Springs positioned cor-
rectly?
Are the Paper Take-Up
7 Rolls deformed, worn, or
dirty with paper dust?
Is a signal being output
from PWB-A to the Paper
Take-Up Solenoid?
8
Is the Clutch Spring
9
deformed or worn?
Continued on next page
Check Item Result
Does the voltage across
PJ4A-9 (1st Drawer) or
PJ3A-2 (2nd Drawer) on
PWB-A and GND change
from DC24V to DC0V
when the Start Key is
pressed?
T-16
Action
Instruct the user to use the
NO paper that meets product
specifications.
Change the paper.
YES Instruct the user in how to
store the paper.
Instruct the user to load the
NO paper so that it rests under
the Fingers.
Replace the Fingers.
YES
Instruct the user in how to
NO position the Edge Stop or
Guide.
Change the position of the
NO Springs or add one as nec-
essary.
Clean or replace the Paper
YES Take-Up Rolls.
Adjust the Solenoid stroke.
YES
Check the Solenoid.
Replace PWB-A.
NO
Replace the Clutch Spring.
YES