Minolta EPI 054 User Manual page 253

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.06.09
[Service Mode
Choice No.
C-5
Select either PM Counter or Copy Kit Counter.
Data
NOTE
If this function is set to "2," the copier gives an indication to replace
the IU and inhibits the initiation of a new copy cycle even if C-4 is set
to "0."
C-6
Select whether to enable or disable copying according to whether the
For 18/23 cpm
Plug-In Counter is plugged in or not.
Copier only
Data
Description
NOTE
Be sure to set this function to "1" when the Plug-In Counter is
installed.
C-7
Select whether or not to inhibit copying when IU Counter has counted
60K.
Data
Description
Default: 0 (inch areas) / 1 (metric areas)
C-15
Select whether or not to inhibit copying when a toner-empty condition
is detected.
Data
Description
NOTE
If "1" is set, the copier inhibits copying when it detects a T/C of 3.5%
or lower.
Tech. Rep. Choice]
Setting (The default is
<PM Counter>
0
Copy Kit Counter: Copying not inhibited after the
1
counter has counted down to zero.
Copy Kit Counter: Copying inhibited after the counter
2
has counted down to zero.
<Plug-In Counter Copying Enable/Disable>
0
Permits copying even
when the Plug-In Counter
is not plugged in.
<IU 60K Stop>
0
Permits copying.
<Toner Empty Stop>
0
Permits copying.
S-22
.)
Highlighted
Description
PM Counter
1
Inhibits copying when the
Plug-In Counter is not
plugged in.
1
Inhibits copying.
1
Inhibits copying.