Minolta EPI 054 User Manual page 144

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 GENERAL, MECHANICAL/ELECTRICAL
98.04.24
1174SBM1308A
13-8. Paper Take-Up Roll
Since the Paper Lifting Plate is raised at all times by the Paper Lifting Springs, paper is
wedged in the mechanism when the Drawer is slid out of the copier if the Paper Take-Up
Roll is round in shape. So the Take-Up Roll is semicircular and the circular part of the Roll is
positioned on top at times other than take-up. For convenience, we call this position of the
Paper Take-Up Roll the "retracted" position.
The Paper Take-Up Roll is grooved to keep good friction even under heavy loading. The 1st
Drawer, which is a universal type to accommodate paper of different sizes, is provided with
five (four in areas using only inch paper) Paper Take-Up Rolls. The 2nd Drawer accommo-
dating paper of a fixed size only is equipped with two Rolls whose positions must be
changed according to the paper size. (For the positions, see DIS/REASSEMBLY, ADJUST-
MENT.)
The Paper Take-Up Roll is driven when the Paper Take-Up Solenoid is energized. The Roll
is turned one complete turn for each single sheet of paper.
The Paper Take-Up Sensor is used to detect whether a sheet of paper has been properly
taken up or not.
Paper Take-Up Roll
Paper Take-Up Solenoid (SL2, SL3)
Ratchet
1139M064AA
Ratchet
1151M025AA
Vertical Transport Roller
Paper Take-Up Sensor (PC55, PC56)
Actuator
1139M066AA
M-50