Minolta EPI 054 User Manual page 141

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 MECHANICAL/ELECTRICAL
98.04.24
1174SBM1305A
13-5. Universal Tray (1st Drawer) Paper Size Detection
The length (feeding direction) and width (crosswise direction) of the paper are indepen-
dently detected and the copier determines the paper size by combining the two separate
detections made.
On the bottom of the tray is a lever fitted to the Trailing Edge Stop and another lever fitted to
the Edge Guide. These levers actuate and deactuate Paper Size Detecting Switches to
allow the copier to determine a particular paper size.
The Marketing Area Switch is used to set the type of paper to be used (inch or metric).
S62
Marketing Area
S61 S63
Switch S66
Paper Size Detecting Switches
Length (FD)
S61 S62 S63
ON ON ON
ON ON OFF
ON OFF OFF
OFF OFF OFF
OFF OFF ON
OFF ON ON
OFF ON OFF
The 2nd Drawer accepts only paper of a fixed size and has no paper size detecting system.
(The paper size is input from the control panel using a Tech. Rep. Mode.)
Drawer Set Detecting
S64
Switch S65
NOTE
The number and the installed position of
the Paper Take-Up Rolls vary depending on
the marketing areas: inch or metric. See
pp. M-43 and M-44 for the sizes of the
paper that can be taken up and fed out of
the drawer.
1151M003AA
Width (CD) Paper Length
S64
– 402.0~402.0
OFF
402.0~349.2
ON
OFF
349.4~317.2
ON
– 317.2~272.0
OFF
272.0~222.0
ON
OFF
222.0~195.0
ON
OFF
195.0~195.0
ON
M-47
Inch/Metric Setting Switch S66
Metric Inch
11" × 17"
A3
8-1/2" × 14"
B4
11" × 14"
8-1/2" × 14"
FLS
11" × 14"
A4L Letter L
Letter L
B5L
Letter C
A5L Invoice L
A4L Letter C
Letter C
B5C
Letter L