Minolta EPI 054 User Manual page 45

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
1149D040AA
1149D041AB
1149D042AA
1149D043AA
1139D142AA
3. Fit the belt in position and secure Scanner Motor
M4 (three screws).
4. Hook the length of cable on the left (looking at the
copier from the rear), around Pulleys C and B and
secure it to the frame.
5. Peeling off the tape, pull the length of cable on the
right (looking at the copier from the rear) and hook
it onto Pulleys A and B.
NOTE
• Hook the length of cable on the left (looking at the
copier from the rear) onto the lower groove in Pully
B. (Fit the round terminal as illustrated on the left.)
• Hook the length of cable on the right (looking at the
copier from the rear) onto the upper groove in Pulley
B.
6. Fit the cable into the groove in the cable guide and
hook the spring.
7. Mount PWB-A (four screws).
D-26