Yamaha VMX12H Supplementary Service Manual page 42

FRONT FORK
ON
IN STALL
Reverse the "REMOVAL" procedure.
Note the following points.
Front
Temporary tighten the pinch bolts.
NOTE:
Be sure the inner fork tube end is flush with
the top of the handle crown.
2. Tighten
Pinch bolts (under bracket)
Cap bolt (front fork)
•
Pinch holt ,handle crown)
Pinch bolt (lower bracket):
23 Nm (2.3 m kg, 17
Cap bolt (front fork):
23 Nm (2.3
Pinch bolt (handle crown):
23 Nm (2.3 m kg, 17 ft
.
3. Adjust:
Front fork air pressure
Refer to FRONT FORK ADJUSTMENT" in
the CHAPTER 2.
Install:
4.
Fork brace
Front fender
.
5.Install:
Frontwheel
Front wheel axle:
60 Nm (6.0 m kg, 43
bolt
Pinch (wheel axle):
20 Nm (2.0 m kg, 14
-14-
ft
ft
m kg, 17
ft Ib)
ft Ib)