Yamaha VMX12H Supplementary Service Manual page 272

FRONT FORK
6-33
8. Install:
Fork spring
With smaller pitch side up.
*Spring seat
bolt
Temporarily tighten the cap bolt.
INSTALLATION
1. Install:
Front
underbracket.
Circlip
Onto inner tube.
Apply a light coat of lithium base grease
to the O-rings in the air joint bracket.
joint bracket
Rubber damper
Over inner fork tube.
2.
Tighten:
Pinch bolts (under bracket)
Temporarily tighten the pinch bolts.
NOTE:
Position the inner tube end so that it i s flush
with the top of the steering crown.
3. Tighten:
Pinch bolts (under bracket)
Pinch Bolts (Under Bracket):
23 Nm (2.3
NOTE:
Do not tighten the pinch bolt (steering crown)
in this
stage.
4. Tighten:
bolt
Use the Front Fork Cap Socket
01104).
*Pinch bolt (steeringcrown)
23 Nm (2.3
Pinch Bolts (Steering Crown) :
I
20 Nm (2.0
17
17
I
1 4