Battery Inspection; Starter Relay Test - Yamaha VMX12H Supplementary Service Manual

.
.
7-13
B A T T E R Y INSPECTION
1. Inspect:
Refer to "CHAPTER
SPECTION" section.
,
STARTER R E L A Y TEST
1. Inspect:
Poor condition
B y the following inspection steps.
Starter relay inspection steps:
ignition switch to "ON", engine stop
switch to " RUN" and shift pedal to
R A L".
the starter motor.
the starter switch and check to see if
the starter relay clicks.
Starter relay clicking
Starter relay not clicking
resistance.
2. Measure:
O u t of specification
B y the following measurement steps.
Starter relay resistance measurement steps:
.Disconnect
positive lead.
to the starter relay.
Red
Starter Relay Resistance:
the resistance is not within specification,
replace the starter relay.
2
B A T T E R Y IN-
realy
Replace.
the seat.
the starter motor lead
Starter relay OK.
Measure coil
relay resistance
Replace.
the lead and the battery
the Pocket Tester
the coil resistance.
3.5 10% at 20°C (68°F)
from
leads