in)
1.5 mm (0.06
14
(0.55
(3.94 in)
mm
SHAFT DRIVE
FINAL DRIVE GEAR
Gear Lash Measurement
1. Secure the gear case
support.
2. Remove:
Drain plug
Drain the oil.
3. Install:
A specified bolt
the drain plug
4.
Finger tighten the bolt until it holds the
ring gear.
NOTE:
Do not over tighten the bolt; finger-tight is
sufficient.
5. Attach:
Lash Measurement Tool
01 230)
Dial Gauge
(YU-03097)
Position mark
6. Measure:
lash
Gently rotate the gear coupling from
engagement t o engagement.
Over specified limit
Final Gear Lash:
-
0.10
0.20 mm (0.004
NOTE:
Measure the gear lash a t 4 positions. Rotate the
shaft 90" each time.
Gear Lash Adjustment
1. Remove:
Nuts (bearing housing)
Bolts (bearing housing)
NOTE:
Working in a crisscross pattern, loosen nut
turn each. Remove them after all are loosened.
in a vise or other
Adjust.
-
0.008 in)
6-52