Yamaha VMX12H Supplementary Service Manual page 178

M I DDL E GEAR SERVICE
5. Measure:
*Starting torque (driven pinion gear)
Under specification
Starting Torque (Driven Pinion Gear):
0.4
0.29
Never exceed the standard starting torque.
*Be sure to tighten the driven pinion gear nut
slowly, carefully checking measurements each
time. Exceeding the standard starting torque
may depress t h e collapsible collar, requiring
reassembly.
To
reassemble, you must replace the collapsible
collar and repeat t h e steps in 4 and
the standard starting torque.
6. Position:
Yoke
Into the U-joint.
7. Lubricate:
Bearings
Wheel Bearing Grease
8. Install:
Bearings
Onto the yoke.
Check each bearing. The needles can easily fall
out of their races. Slide t h e yoke back and forth
on the bearings; the yoke will not go all the way
onto a bearing if a needle is out of palce.
9. Press each bearing i n t o U-joint using a
suitable socket.
NOTE:
Bearing must be inserted far enough into
joint so that circlip can be installed.
10. Install:
Into groove of each bearing.
Repeat steps from 4.
0.5 Nm (0.04 0.05
kg,
0.36 Ib)
5
to obtain
3-54