Yamaha VMX12H Supplementary Service Manual page 299

SHAFT DRIVE
Hundredths
I
I
In the example above, the calculated shim
thickness i s 0.46 mm. The chart instructs
however, t o round off the 6 t o 5.
Thus you should use a
2.
Install:
*Shims (proper size as calculated)
Final drive shaft assembly
Bearing retainer (final drive shaft)
Use a Final Drive Shaft Bearing Retainer
Wrench
NOTE:
The bearing retainer has left-hand threads; turn
retainer counterclockwise t o tighten it.
Bearing Retainer:
110 Nm (11.0
Install:
Coupling gear
nut (coupling gear)
Use a Final Drive Shaft Holder
01
locking Nut
110 Nm (11.0
I
LOCT
4. Install:
Ring gear assembly (without thrust washer)
5.
Adjust:
lash
Refer to "Gear Lash Measurement and
Adjustment" section.
6.
Ring gear thrust clearance
By the following measurement and selec-
tion steps.
Round
I
0
shims.
i
ing Gear)
80
6-60