Yamaha VMX12H Supplementary Service Manual page 270

FRONTFORK
6-3
1
3. Inspect:
Damper rod
Replace.
Contamination Blow out all oil passages
with compressed air.
4. Inspect:
@O-ring(cap bolt)
lock piece
Damage Replace.
Seals
Replace.
ASSEMBLY
Before assembling, clean and inspect all parts
and replace when necessary.
NOTE:
In front fork assembly, be sure to use following
new parts. Do not reuse them.
bush
Guide bush
seal
Dust seal
1. Install:
Rebound spring
Damper rod
Allow the rod t o slide slowly down the
tube until the it protrudes from the
bottom.
Oil lock
Fit oil lock piece over damper rod sticking
out of the inner fork tube.
2. Install:
Inner fork tube
Into outer tube.