Yamaha VMX12H Supplementary Service Manual page 233

THROTTLE CABLE CYLINDER
Second step:
a. Loosen the locknut
b. Turn the adjuster (carburetor side) counter-
clockwise a little.
c. Turn adjuster (throttle grip side) clock-
wise so that the free play (throttle grip) is
within 4
d. Check to see if throttle valve operates a t
full open.
If not, repeat steps a
e. Tighten locknut (carburetor side).
f. Check to see if throttle valve operates a t
full open or full closed.
Throttle valve fails to operate a t full open
or full closed
Third step:
i s correct.
NOTE:
Be sure that the silver throttle cable
sitioned opposite the adjusters.
Check the position of the control cable
sliders in the throttle cable cylinder.
NOTE:
sure the open side slider (silver cable side)
falls between the three adjustment marks on
the carburetor side.
sure the closed side slider falls between
the two adjustment marks on the throttle
grip side.
the
marks then the throttle
replaced.
Cable adjustment mark (Open side)
Cable adjustment mark (Closed side)
(carburetor side).
- -
7 mm (0.16 0.28 in).
-
d.
Perform the next step.
to see if throttle cable installation
fall outside the adjustment
is po-
must be
5-12