Konica Minolta bizhub 200 Service Manual page 240

Theory of Operation Ver. 1.0 Aug. 2005
4. When the Elevator Tray Home Position Sensor (PC3-FN) is activated a second time
after the ascent motion of the Elevator Tray has been started, it is determined that
the Elevator Tray is now located at the exit port for the 2nd Exit Tray.
5. Drive is stopped when the Elevator Tray Upper Limit Sensor is activated with the
position sensor of the target tray in the activated position.
* If an additional AK-1 tray is installed, the additional tray is at the exit port when the posi-
tion sensor is activated twice and the 2nd Tray is at the exit port when the position sensor
is activated three times.
B. Paper Full Detection
• When the Elevator Tray Home Position Sensor changes from the activated to deactivated
state with the Top Face Detection Sensor in the activated state, a paper full condition is
detected and the corresponding message will appear on the control panel.
• To protect the Exit Roller from the Elevator Tray in motion, the Shutter is opened or
closed while the Elevator Tray is moving.
• The Elevator Motor (M11-FN) provides the drive for the Elevator Tray.
• The Shutter Opening Motor (M12-FN) opens or closes the exit port.
5. Operations
Elevator Tray Home
Position Sensor (PC3-FN)
4349T2C514AA
15