Konica Minolta bizhub 200 Service Manual page 127

5. Operation
Operation 8
• A print cycle is carried out to produce a print image of
the third page of the original to the second 1-sided print.
• At the same time, the fourth 1-sided print is transported
toward and into the Duplex Unit.
• The third 1-sided print remains in the standby state
before the Duplex Unit Transport Roller until the next
paper motion is carried out.
• At the same time, the main unit starts a paper take-up
and feed sequence for the fifth sheet of paper.
Operation 9
• While feeding the second 2-sided print out of itself, the
main unit carries out a print cycle for producing a print
image of the tenth page of the original on the fifth sheet
of paper.
• The third 1-sided print stands by before the Duplex Unit
Transport Roller.
• The fourth 1-sided print stops temporarily when there is
a predetermined spacing or less away from the second
2-sided print.
Operation 10
• The fifth 1-sided print is transported to the Switchback
Unit.
• At the same time that the fifth 1-sided print is trans-
ported, the third 1-sided print that has stood by in the
Duplex Unit for the subsequent paper motion is trans-
ported into the main unit.
• At the same time that the third 1-sided print is trans-
ported, the fourth 1-sided print remains in the standby
state before the Duplex Unit Transport Roller until the
next paper motion is carried out.
• Steps 8 through 10 are repeated.
14
Theory of Operation Ver. 1.0 Aug. 2005
8
2
1
4
3
2
1
4
3
2
1
3 4
6
4346T2C525AA
8
10
6
4346T2C526AA
10
8
6
4346T2C527AA