Konica Minolta bizhub 200 Service Manual page 126

Theory of Operation Ver. 1.0 Aug. 2005
Operation 4
• The third 1-sided print is transported to the Switchback
Unit.
• At the same time that the third 1-sided print is trans-
ported, the first 1-sided print that has stood by in the
Duplex Unit for the subsequent paper motion is trans-
ported into the main unit.
• The second 1-sided print is transported toward and into
the Duplex Unit.
Operation 5
• A print cycle is carried to produce the print image of the
first page of the original on the first 1-sided print.
• At the same time, the third 1-sided print is transported
toward and into the Duplex Unit.
• The second 1-sided print remains in the standby state
before the Duplex Unit Transport Roller until the next
paper motion is carried out.
• At the same time, the main unit starts a paper take-up
and feed sequence for the fourth sheet of paper.
Operation 6
• While feeding the first 2-sided print out of itself, the main
unit carries out a print cycle for producing a print image
of the eighth page of the original on the fourth sheet of
paper.
• The second 1-sided print stands by before the Duplex
Unit Transport Roller.
• The third 1-sided print stops temporarily when there is a
predetermined spacing or less away from the second 1-
sided print.
Operation 7
• The fourth 1-sided print is transported to the Switchback
Unit.
• At the same time that the fourth 1-sided print is trans-
ported, the second 1-sided print that has stood by in the
Duplex Unit for the subsequent paper motion is trans-
ported into the main unit.
• At the same time that the second 1-sided print is trans-
ported, the third 1-sided print remains in the standby
state before the Duplex Unit Transport Roller until the
next paper motion is carried out.
5. Operation
4
6
2
4346T2C521AA
6
1 2
4
4346T2C522AA
6
2
1
8
4
4346T2C523AA
8
6
2
1
4
4346T2C524AA
13