Konica Minolta bizhub 200 Service Manual page 124

Theory of Operation Ver. 1.0 Aug. 2005
Operation 6
• The third 1-sided print is transported to the Switchback
Unit.
• Immediately before the third 1-sided print is fed out by
the Exit Roller of the Switchback Unit, the direction of
rotation of the Exit Roller is reversed and the third 1-
sided print is transported toward and into the Duplex
Unit.
• At the same time that the third 1-sided print is trans-
ported, the second 1-sided print that has stood by in the
Duplex Unit for the subsequent paper motion is trans-
ported into the main unit.
Operation 7
• The main unit carries out the first print cycle for the sec-
ond sheet of paper to produce the print image of the
third page of the original.
• At the same time, the first 1-sided print for the third is
transported through the Duplex Unit.
• At the same time, the forth sheet of paper is taken up
and fed into the main unit.
Operation 8
• While feeding the second 2-sided print out, main unit
produces the print image of the 8th page of the original
on the fourth sheet of paper.
• The third 1-sided print remains in the standby state
before the Duplex Unit Transport Roller until the next
paper motion is carried out.
Operation 9
• The fourth 1-sided print is transported to the Switchback
Unit.
• Immediately before the fourth 1-sided print is fed out by
the Exit Roller of the Switchback Unit, the direction of
rotation of the Exit Roller is reversed and the fourth 1-
sided print is transported toward and into the Duplex
Unit.
• At the same time that the fourth 1-sided print is trans-
ported, the third 1-sided print that has stood by in the
Duplex Unit for the subsequent paper motion is trans-
ported into the main unit.
• Steps 7 through 9 are repeated.
5. Operation
6
2
1
4
4346T2C515AA
6
2
3 4
1
4346T2C516AA
4
8
3
2
1
6
4346T2C517AA
8
4
3
2
1
6
4346T2C518AA
11