Assembling The Rear Constant Velocity Joints - Yamaha YXR70FX Service Manual

REAR CONSTANT VELOCITY JOINTS, FINAL DRIVE
È
1
New
È
1
New
È
É
É
GEAR AND DRIVE SHAFT
ASSEMBLING THE REAR CONSTANT
VELOCITY JOINTS
È Wheel side
É Gear case side
1. Install:
• dust boot
• clip 1
3
• off-set joint 2
• joint shaft 3
M MMM
a. Install the clip 1.
b. Install the off-set joint 2.
3
TIP:
• Install the clip 1 into the groove in the joint
• Secure the off-set joint in a vise, and then fit
2
L LLL
2. Install:
• dust boot
1
• ball bearing 1
• circlip 2
2
New
• double off-set joint 3
• clip 4
TIP:
• Securely install the circlip into the groove in
• Securely install the clip into the groove in the
3
4
New
7 - 29
New
M MMM M M MMM M M MMM M
shaft as shown.
the joint shaft into the off-set joint using a
hammer.
L LLL L L LLL L L LLL L
New
New
the joint shaft.
double off-set joint.
DRIV
M MMM M M MMM M MMM
L LLL L L LLL L LLL