FRONT CONSTANT VELOCITY JOINTS, DIFFERENTIAL
1
GEAR AND DRIVE SHAFT
DISASSEMBLING THE UNIVERSAL JOINT
1. Remove:
• universal joint
M
MMM
M MMM
M
a. Remove the circlips 1.
b. Place the universal joint in a press.
c. With a suitable diameter pipe 2 beneath
the yoke 3, press the bearing 4 into the
pipe as shown.
TIP:
It may be necessary to lightly tap the yoke with
a punch.
d. Repeat the steps for the opposite bearing.
e. Remove the yoke.
L
LLL
L LLL
L
2. Remove:
• universal joint yoke
Use a universal joint holder 1.
Universal joint holder
EBS00163
REMOVING THE DIFFERENTIAL GEAR
ASSEMBLY
1. Remove:
• differential gear assembly 1
TIP:
_
The ring gear and the differential gear should
be fastened together. Do not disassemble the
differential gear assembly.
NOTICE
_
The differential gear assembly is assem-
bled into a proper unit at the factory by
means of specialized equipment. Do not
attempt to disassemble this unit. Disas-
sembly will result in the malfunction of the
unit.
7 - 11
DRIV
M MMM
M
M MMM
M
M MMM
M
L LLL
L
L LLL
L
L LLL
L
90890-04062, YM-04062
M MMM
M
MMM
L LLL
L
LLL