Yamaha YXR70FX Service Manual page 96

Off-road motorcycle
Hide thumbs Also See for YXR70FX:
Table of Contents

Advertisement

MEASURING THE COMPRESSION PRESSURE
b. With the throttle wide open, crank the
engine until the reading on the compression
gauge stabilizes.
WARNING
_
To prevent sparking, ground the spark plug
lead before cranking the engine.
c. If the compression pressure is above the
maximum specification, check the cylinder
head, valve surfaces and piston crown for
carbon deposits.
Carbon deposits → Eliminate.
d. If the compression pressure is below the
minimum specification, squirt a few drops of
oil into the cylinder and measure again.
Refer to the following table.
Compression pressure
(with oil applied into the cylinder)
Reading
Higher than
without oil
Same as without
oil
L
LLL
L LLL
L
L LLL
L
8. Install:
• spark plug
9. Connect:
• spark plug cap
10.Install:
• rear console
• seats
Refer to "SEATS, REAR CONSOLE AND
INSTRUMENT PANELS" in chapter 8.
3 - 12
CHK
ADJ
Diagnosis
Piston ring(s) wear
or damage →
Repair.
Piston, valves,
cylinder head
gasket or piston
rings possibly
defective → Repair.
L LLL
L
L LLL
L
L LLL
L
LLL
13 Nm (1.3 m · kg, 9.4 ft · lb)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rhino 700 2008Rhino 700fi 2008Rhino yxr70fx 2008

Table of Contents