Table of Contents
Advertisement
REAR CONSTANT VELOCITY JOINTS, FINAL DRIVE
GEAR AND DRIVE SHAFT
Selecting thrust washer
1. Measure:
M
a. Place four pieces of Plastigauge
b. Install the final gear assembly and tighten
TIP:
"C"
Do not turn the drive pinion gear and ring gear
when measuring the clearance with Plasti-
gauge
c. Remove the final gear assembly.
d. Measure the thrust clearance. Calculate the
e. If out of specification, select the correct
L
7 - 36
• ring gear thrust clearance "C"
MMM
M MMM
M
M MMM
M
M MMM
M
the originally fitted thrust washer and the
ring gear.
the bolts to specification.
M8 bolts (ring gear bearing hous-
ing)
23 Nm (2.3 m · kg, 17 ft · lb)
M10 bolts (ring gear bearing
housing)
40 Nm (4.0 m · kg, 29 ft · lb)
®
.
width of the flattened Plastigauge
Ring gear thrust clearance
0.1 ~ 0.2 mm (0.004 ~ 0.008 in)
washer.
LLL
L LLL
L
L LLL
L
L LLL
L
DRIV
M MMM
M
M MMM
M
MMM
®
between
®
1.
L LLL
L
L LLL
L
LLL
Advertisement
Table of Contents
Troubleshooting
