Table of Contents
Advertisement
FRONT CONSTANT VELOCITY JOINTS, DIFFERENTIAL
1
GEAR AND DRIVE SHAFT
3. Install:
• ring gear fix bolt (M10) 1
(into the drain plug hole)
NOTICE
_
Finger tighten the bolt until it holds the ring
gear. Otherwise, the ring gear will be dam-
aged.
4. Attach:
• gear lash measurement tool 2
• dial gauge 3
a Measuring point is 22.5 mm (0.86 in)
5. Measure:
• gear lash
Gently rotate the coupling gear from
engagement to engagement.
TIP:
_
Measure the gear lash at four positions. Rotate
the shaft 90° each time.
EBS00176
ADJUSTING THE DIFFERENTIAL GEAR
LASH
2
1. Remove:
• differential drive pinion gear shim(s) 1
• differential gear assembly 2
7 - 18
DRIV
Ring gear fix bolt (M10)
90890-01527, YM-01527
Gear lash measurement tool
90890-01475
Middle drive gear lash tool
YM-01475
Differential gear lash
0.05 ~ 0.25 mm
(0.0020 ~ 0.0098 in)
Advertisement
Table of Contents
Troubleshooting
