Configuring Snmp With A Configuration Editor; Defining System Identification Information (Required); Configuring Snmp Agents And Communities (Required); Managing Snmp Trap Groups (Required) - Juniper J-Series Administration Manual

J-series Services Router Administration Guide

Configuring SNMP with a Configuration Editor

To configure SNMP on a Services Router, you must perform the following tasks
marked (Required). For information about using the J-Web and CLI configuration
editors, see the J-series Services Router Basic LAN and WAN Access Configuration Guide.

Defining System Identification Information (Required)

Basic system identification information for a Services Router can be configured with
SNMP and stored in various MIBs. This information can be accessed through SNMP
requests and either queried or reset. Table 31 on page 54 identifies types of basic
system identification and the MIB object into which each type is stored.
Table 31: System Identification Information and Corresponding MIB Objects
System Information
Contact
System location
System description
System name override
To configure basic system identification for SNMP:
1.
2.
3.
4.
Table 32: Configuring Basic System Identification
Task
Navigate to the SNMP level in the
configuration hierarchy.
54

Configuring SNMP with a Configuration Editor

Defining System Identification Information (Required) on page 54
Configuring SNMP Agents and Communities (Required) on page 55
Managing SNMP Trap Groups (Required) on page 56
Controlling Access to MIBs (Optional) on page 57
Navigate to the top of the configuration hierarchy in either the J-Web or CLI
configuration editor.
To configure basic system information using SNMP, perform the configuration
tasks described in Table 32 on page 54.
If you are finished configuring the network, commit the configuration.
To check the configuration, see "Verifying the SNMP Configuration" on page 58.
J-Web Configuration Editor
1. In the J-Web interface, select
Configuration>View and Edit>Edit
Configuration.
2. Next to Snmp, click Configure or Edit.
MIB
sysContact
sysLocation
sysDescr
sysName
CLI Configuration Editor
From the
[edit]
enter
edit snmp
hierarchy level,