Event Policy Overview; Configuring Event Policies - Juniper J-Series Administration Manual

actions when specific events occur. These actions can either help you diagnose a
fault or take corrective action.
This section contains the following topics:

Event Policy Overview

In response to events, event policies can execute the following actions:
To view a list of the events that can be referenced in an event policy, issue the
syslog ?
user@host> help syslog ?
Possible completions:
For information about these events, see the JUNOS System Log Messages Reference.

Configuring Event Policies

To configure event policies:
1.
2.
3.
Event Policy Overview on page 95
Configuring Event Policies on page 95
Ignore the event—Do not generate a system log message for this event and do
not process any further policy instructions for this event.
Raise a trap—Initiate an SNMP trap to notify SNMP trap-based applications when
the event occurs.
Upload a file—Upload a file to a specified destination. You can specify a transfer
delay, so that, on receipt of an event, the upload process begins after the
configured transfer delay. For example, a transfer delay can ensure that a core
file has been completely generated before being uploaded.
Execute CLI operational mode commands—Execute commands when an event
occurs. The output of these commands is stored in a file, which is then uploaded
to a specified URL.
Execute operation scripts—Execute operation scripts when an event occurs. The
output of the operation scripts is stored in a file, which is then uploaded to a
specified URL. For information about operation scripts, see "Automating Network
Management and Troubleshooting with Operation Scripts" on page 92.
command:
<syslog-tag>
ACCT_ACCOUNTING_FERROR
ACCT_ACCOUNTING_FOPEN_ERROR
ACCT_ACCOUNTING_SMALL_FILE_SIZE
...
Navigate to the top of the configuration hierarchy in either the J-Web or CLI
configuration editor.
Perform the configuration tasks described in Table 45 on page 96.
If you are finished configuring the network, commit the configuration.
Chapter 6: Automating Network Operations and Troubleshooting
System log tag
Error occurred during file processing
Open operation failed on file
Maximum file size is smaller than record size
Running Self-Diagnostics with Event Policies
help
95