Before You Begin - Juniper J-Series Administration Manual

J-series Services Router Administration Guide
lines of the configuration that contain
using a pipe into the
user@host> show configuration | match address
address-range low 192.168.3.2 high 192.168.3.254;
address-range low 192.168.71.71 high 192.168.71.254;
address 192.168.71.70/21;
address 192.168.2.1/24;
address 127.0.0.1/32;
For a complete list of the filters, type a command, followed by the pipe, followed by
a question mark (?):
user@host> show configuration | ?
Possible completions:
You can specify complex expressions as an option for the
For more information about command output filtering and creating match
expressions, see the JUNOS CLI User Guide.
NOTE: To filter the output of configuration mode commands, use the filter commands
provided for the operational mode commands. In configuration mode, an additional
filter is supported. See the J-series Services Router Basic LAN and WAN Access
Configuration Guide.

Before You Begin

To use the J-Web interface and CLI operational tools, you must have the appropriate
access privileges. For more information about configuring access privilege levels,
see "Adding New Users" on page 11 and the JUNOS System Basics Configuration
Guide.
106
Before You Begin
match
compare Compare configuration changes with prior version
count Count occurrences
display Show additional kinds of information
except Show only text that does not match a pattern
find Search for first occurrence of pattern
hold Hold text without exiting the --More-- prompt
last Display end of output only
match Show only text that matches a pattern
no-more Don't paginate output
request Make system-level requests
resolve Resolve IP addresses
save Save output text to file
trim Trim specified number of columns from start of line
, issue the
address
filter:
command
show configuration
and filters.
match except