Juniper J-Series Administration Manual page 294

J-series Services Router Administration Guide
Figure 26: Main Quick Configuration Page for RPM
Figure 27: Probe Test Quick Configuration Page for RPM
To configure RPM parameters with Quick Configuration:
1.
2.
3.
4.
Table 140: RPM Quick Configuration Summary
Field Function
Performance Probe Owners
Owner Name Identifies an RPM owner for which one or more RPM
(required) tests are configured. In most implementations, the
owner name identifies a network on which a set of
tests is being run (a particular customer, for example).
Identification
Test name (required) Uniquely identifies the RPM test
Target (Address or IP address or URL of probe target
URL) (required)
Source Address Explicitly configured IP address to be used as the
probe source address
272
Configuring RPM with Quick Configuration
ERROR: Unresolved graphic fileref="s020257.gif" not found in
"\\teamsite1\default\main\TechPubsWorkInProgress\STAGING\images\".
ERROR: Unresolved graphic fileref="s020258.gif" not found in
"\\teamsite1\default\main\TechPubsWorkInProgress\STAGING\images\".
In the J-Web interface, select Configuration>Quick Configuration>Realtime
Performance Monitoring.
Enter information into the Quick Configuration page for RPM, as described in
Table 140 on page 272.
From the main RPM Quick Configuration page, click one of the following buttons:
To apply the configuration and stay on the Quick Configuration RPM page,
click Apply.
To apply the configuration and return to the Quick Configuration main page,
click OK.
To cancel your entries and return to the Quick Configuration RPM page, click
Cancel.
To check the configuration, see "Verifying an RPM Configuration" on page 285.
Your Action
Type the name of the RPM owner.
Type the name of the RPM test.
Type the IP address, in dotted decimal
notation, or the URL of the probe target. If the
target is a URL, type a fully formed URL that
includes http:// .
Type the source address to be used for the
probe. If the source IP address is not one of
the router's assigned addresses, the packet
uses the outgoing interface's address as its
source.