Tracing Multicast Routes From The Cli - Juniper J-Series Administration Manual

J-series Services Router Administration Guide
Table 123: CLI traceroute monitor Command Output Summary
Field
host
size
psize
Keys
Help
Display mode
Restart statistics
Order of fields
quit
Packets
number
Host
Loss%
Pings
Snt
Last
Avg
Best
Wrst
StDev

Tracing Multicast Routes from the CLI

Use CLI
from-source
240
Using CLI Diagnostic Commands
Description
Hostname or IP address of the Services Router issuing the
Size of ping request packet, in bytes.
Displays the help for the CLI commands.
Press H to display the help.
Toggles the display mode.
Press D to toggle the display mode
Restarts the
traceroute monitor
Press R to restart the traceroute monitor
Sets the order of the displayed fields.
Press O to set the order of the displayed fields.
Quits the
traceroute monitor
Press Q to quit the traceroute monitor
Number of the hop (router) along the route to the final destination host.
Hostname or IP address of the router at each hop.
Percent of packet loss. The number of ping responses divided by the number of ping
requests, specified as a percentage.
Number of ping requests sent to the router at this hop.
Most recent round-trip time, in milliseconds, to the router at this hop.
Average round-trip time, in milliseconds, to the router at this hop.
Shortest round-trip time, in milliseconds, to the router at this hop.
Longest round-trip time, in milliseconds, to the router at this hop.
Standard deviation of round-trip times, in milliseconds, to the router at this hop.
mtrace commands to trace information about multicast paths. The
command displays information about a multicast path from a source to
traceroute monitor
command.
command.
command.
command.
command.
mtrace